Shingle roofing is the backbone of residential roofing in Alvord. Whether you're choosing architectural shingles for their dimensional look or three-tab shingles for budget-friendly coverage, the installation process is what determines how long they last. Alvord Roofing & Maintenance follows manufacturer nailing specs and overlap requirements on every job.
We install every shingle roof to manufacturer specifications. That means 4-6 nails per shingle in the designated nailing zone, proper offset between courses, starter strips along the eave, and ridge cap shingles at every hip and ridge. When the manufacturer inspector shows up, your roof passes.
Our Shingle Roofing Process
Consultation & Inspection
Free on-site inspection. We measure, assess your roof deck condition, and walk you through architectural vs. three-tab shingles with realistic pricing. No pressure, just facts.
Strip & Inspect
We strip the old shingles, underlayment, and damaged flashing down to the roof deck. Every square foot of OSB or plywood sheathing inspected for rot, water damage, and soft spots. Compromised decking replaced before new materials go down.
Waterproofing Layer
Synthetic underlayment across the full roof deck. Ice-and-water shield in valleys, along eaves, and around chimney flashing, pipe boots, and vent boots. New drip edge installed at every eave and rake. Step flashing and counter-flashing at all wall transitions.
Shingle Courses
Asphalt shingles laid from eave to ridge with precise offset between courses. Every shingle fastened in the manufacturer's nailing zone — too high or too low voids the warranty. Ridge cap and hip shingles complete the system with ridge vents for balanced attic ventilation.
What Alvord Customers Say
"Best experience we've ever had with a home service company. On time, on budget, and the results exceeded what we expected. Truly top-notch."
"Our neighbors recommended them and now we understand why. Meticulous attention to detail and they treated our home like it was their own."
"We called expecting to wait days, but they were here the same afternoon. Fair pricing, quality work, and they kept us informed every step of the way."
Why Choose Alvord Roofing & Maintenance for Shingle Roofing?
Proper Flashing at Every Penetration
Chimney flashing, step flashing, pipe boots, vent boots, valley channels — every transition sealed with waterproof sealant and proper overlap. Flashing failures cause 90% of roof leaks.
Full Tear-Off Standard
We strip to the deck on every shingle job. No overlay shortcuts. Your underlayment, ice-and-water shield, and flashing are installed on a clean, inspected roof deck.
Nailed to Manufacturer Spec
Every shingle nailed in the designated nailing zone with the correct number of fasteners. This is what keeps the manufacturer warranty valid and the shingles on your roof in high wind.
Manufacturer-Certified Installers
GAF Master Elite, Owens Corning Preferred, CertainTeed SELECT ShingleMaster. Our certifications mean your manufacturer warranty is fully valid from day one.